The Lenco Bennett Retrofit Kit converts Bennett trim tabs to Lenco electric actuators while reusing the existing Bennett trim planes, lower bracket, switch, and mounting holes. The 12V kit includes two electric actuators, two upper mounting brackets, a switch wiring kit, and mounting hardware, with the actuator wires feeding through the existing oil line holes in the transom.

Bennett RetroFit Kit

We make the best boats better!™

Lenco Marine Electric RetroFit Kit for Bennett Trim Tabs

Upgrade your boat with the latest trim tab technology - trouble-free, high performance Lenco electric actuators.

Easy installation:

• Use existing Bennett trim planes, lower bracket and switch
  
• Use all existing mounting holes

• 2 electric actuators
  
• 2 upper mounting brackets
  
• Switch wiring kit
  
• All mounting hardware

• Lenco wire feeds through existing oil line hole in transom
  
• Lenco upper mounting bracket fits existing Bennett mounting holes
  
• Existing Bennett trim tab plane and hinge
  
• Existing Bennett lower bracket

• Remove Bennett actuators, and install Lenco upper mounting brackets on transom
  
• Feed Lenco wires through holes in brackets and through existing oil line holes in transom
  
• Mount Lenco actuators on to new upper brackets and existing Bennett lower brackets
  
• Connect Lenco actuator wires to existing harness.

WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.